Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
hi guys, i have cisco 8102H series router with XR7.8.2 software.it seems when i was configuring my aaa configurations i had a mistake and my 8000 series router is giving me authorization failed. i know the local users password with root privilege but...
Hi EveryoneIs BGP Flow Spec Supported on NCS540 ? i know that it is supported on ios XR and ASR9K and NCS5500 but i don't know if it is supported on NCS540 or not.Can you please help me?
So i have integrated FMC and ISE. now I'm going to use PxGrid Mitigation in my Correlation Policy and this error shows up in my FMC Health.EPS Remediations currently in use will not work with the current pxGrid connection to ISE. Please change your c...
so guys I have a scenario that when incoming calls come from PSTN to my Gateway they must be manipulated.1) 41585290 ----> 8602) 41585000 ----> 2903) 41585... ------> ...as u know i can do these digit manipulations with voice translation rules and wi...
yes and the problem is that there is no password recovery mechanism on this router. The only way seems to be re-imaging the device.also there is a command system recovery on this routers but it is disabled by default so you must enable it manually be...
@Flavio Miranda and also i did not enable that system recovery on it ... how is it even possible that i can authenticate to the device using my local users but i cant get authorization ... what do you suggest mate?
hi dear flavio,i have root users on this router and i can login with them in priviledge mode but when i try to go to configuration terminal it says authorization failed ... it seems i didnt configure any fallback to tacacs cause when i disconnect mgm...
