Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I just configured a 3845 router with hwic-4esw L2 ports and I have assigned Vlan to its own switchport to provide additional routed ports. However, I need to configure QOS to some of these physical interfaces, but it looks like this can only be do...
Hi,I am upgrading our 2610 router to 2811 and I finished moving manually all the configuration to the new 2811. I am noticing that some of command that I have type in where not visible after I type "sh run" like; ip subnet-zero,ip classless, no ip fi...
Hi,Is there a command within router IOS to find out the number of memory chips being installed in 3640 memory banks? also what density are they (ie.. 32/62mb)?Thanks,
Hi,I am getting this message from PIX log "10.17.30.250 %PIX-6-110001: No route to 10.17.50.53 from 10.17.30.11" when I tried pinging 10.17.50.53. Please correct me if i am wrong but I know that PIX is just passing traffic in/out and not routing tra...
Hi,This made sense now so If i have another router (3640) that need IOS upgrade to 12.4(13r)T all the ip classless and ip subnet-zero that are visible in "sh run" should disappear after successfully upgraded and reboot. Right?Thanks a bunch.
Hi,2600 IOS was not being use for 2800. (2811)It has been upgraded to 12.4(13r)T.Secondly, Should I assume that ip subnet-zero,ip classless are default enable as well?Also, is there some kind of white paper that indicates all the default enable/disab...
Hi Jon,Thank you very much for your time and attention. I finally figured it out. I had to advertised the subnet and applied access-list back to back and now 50.0/24 can ping the 30.0/24. I just have to apply the same concept on the other side so it ...
