Unfortunately no. The reason the secondary switch suspends it's vPC member links is because of vPC loop avoidance mechanisms. This is to be expected when communication is disrupted on the peer-link but the primary vPC switch is still alive. When you ...

Here are some ideas to think about, if you run the firewall in transparent mode, you can do vPC to the firewall, do port-channel subinterfaces on the FW and break VLANs out into different contexts. You could do this between VDCs or put multiple custo...

Are you trying to install the 6.2 EPLD while still running 6.1 NXOS? If so you need to upgrade to 6.2, then install the EPLD code. The error message is not a good one, but I am betting that is your issue.HTH,Ant

Hi Manfred,Please try and change the boot variables, "copy run start" and reload the device. They are located toward the bottom of the configuration. Let me know if that resolves the situation.ThanksAnt