Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, I am little confuse regarding licensing in WCS.Mine client bought WCS wit BASE license for 50 LAP (AIR-WCS-WB-1.0-K9), next they upgraded to Location License (AIR-WCS-WL-UG-K9). Now they want to add 50 more LAP. What type of lichens should be buy...
Hi,Have you try new sw realeas 5.2. In see in Cisco documentation to watch out for port number and you firewall ACL. But there is no info what exactly is going on with port after upgrade from LWAPP to CAPWAP. Do LAP stay with LWAPP port 12222 and 122...
Hi,Has anybody configure secure mobility groups on 4402/4404. I put mobility secure-mode enable command on both controllers. Mobility Protocol Port status has change to 16667 (after reboot) but I have Data Path Down. Do I have to configure something ...
Hi everyone,I have this situation:1250 Autonomous (latest IOS, clean config, set ssid, wpa2, channel width 40 MHz). When I send file by FTP I get this:Client => FTP 10-12 MiBFTP => Client 11-13 MiBBut after converting this AP to LAP and connecting to...
HiI have to do some labs with antenna diversity. But I do not have any 1240, 1131, etc right now. I only have 1250. What parameters must be enable/disable to run 1250 as 1240. I have disable 2 RX (B i C) and 1 TX (B). How to disable spatial multiplex...
Hi,I have one more question about indoor/enterprise mesh (name it) and licensing. What kind of license this is ?? Do I have to apply same key or special file in WLC. Pleas be provide more info.Thx in advance.CheersGregory
Hi,If you go to virtual interface and open its properties, you can add address to which should wlc redirect insted of 1.1.1.1. This domain should be used for cert and should be translate to 1.1.1.1 by DNS.CheersGreg
