Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi wanted to get some feedback on the following show command. show platform tcam utilizationCAM Utilization for ASIC# 0 Max UsedMasks/Values Masks/valuesUnicast mac addresses: 6364/6364 1920/1920IPv4 IGMP groups + multicast routes: 1072/1072 1/1IPv4 ...
Hi Exploited,You'd need to provide a lot more information for a meaningful answer.Are you using IPv4 or IPv6 on the network?Figure out what transport protocol your going to be using, is this a fully meshed WAN link? Hub and Spoke? Point to Point? Wha...
Hi Jsmith,So from the above config output you have a default gateway set up (192.168.0.1) as well as a static route to said network in your routing table (the default gateway address as I see from the above is a dynamically assigned address!!! you sh...
Thanks Rick,Probably also worth adding on the reload commandDev#reload in mm | hh:mmexit telnet/ssh connectionrestart telnet/ssh connectionDev# reload canceldev#wrDon't save new or updated config till after you have tested they work for remote access...
Hi ausarian1,The first things I would conciser when looking for a distribution switch would be as follows.What feature set will it need to perform?What type of traffic will the distribution switch need to work with?Are you going to be implementing re...
Hey Leo,Looking at the original post looks like hes running 2 Cisco WS-C2940-8TF-S Switches.I am assuming that the readout from the SW1&SW2#show ip int brief command shows both line status and protocols as down.That to me would scream cable, so they ...
