Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have two routers of Cisco 7206VXR series, with one DS3 linkterminating on each of these routers. These links are MPLS linksproviding WAN connectivity to our office. We need to achieveload-balancing on these links. How can I achieve this?
Hi,I have configured kron based commands on my routers & switches to automate Configuration backups. I've pointed this to one of my windows system to have all the configuration files stored.The configurations is as provided below:kron occurrence back...
I have a triangular topology:Location A, B & C are connected to each other over a MAN link.Location A was connected to Location C over MAN links;Location A :Switch Configinterface FastEthernet7/24 description : Connecting Location B no switchport ban...
Hi, I have configured static routes between two routers. I have 4 links between the routers & have traffic routed. The interface IP address :Router -1:Serial 0/0/0 - 192.168.248.1 255.255.255.252Serial0/1/0 - 192.168.248.5 255.255.255.252Serial0/2/0:...
I have my Cisco 4507R switch in the ROM mon mode & the config-register value is seen to be some junk value. I tried executing the commandconfreg 0x2102. This doesn't work.I get the below options:ommon 5 >confreg Configuration Summary : => load rom a...
Thanks Giuseppe. I am still unable to get the logic of having two differnt AS to the same location. What would happen if we configure the same AS for both the links?
Thanks Guiseppe. Is the max path = 2 because the load balancing is done for 2 links? Also, AS configured for both the links are different. How will SP acheive this?Can you please provide some links which can help me understand this concept better?
Giuseppe,IP-CEF is enabled on our routers & bothe the links are equal cost. Doesn't this mean that for all outbound traffic from these two routers there should be 'per destination' based load-balancing done?For the inbound traffic from MPLS, the Serv...
Hello Giuseppe,The router is running BGP as the External routing-protocol & EIGRP as the internal routing protocol at the LAN end. All the EIGRP routes are getting distributed into BGP & BGP routes into EIGRP.How do I achieve Load balancing? Also, si...
