Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
So we replaced a failed HP (sigh..should have had a Cisco in all along) switch with a backup Cisco 2924-XL. Performed basic config, and plugged it into our 2611 Router. Connection was just fine...THEN:I went and enabled trunking/encapsulation on inte...
Currently have a client with a 3640 running IOS version 12.3(11)T and when we went to setup a VLAN yesterday, noticed their 3640 doesn't support encapsulation. Is this a software or hardware issue?If a software issue, what image do I need to upgrade ...
I have a 2611 Router and am trying to OPEN port 5555 to both allow access in AND out...any recommendations on an IP statement?SW Version: 12.3IP subnet is 192.168.0.0/24
Again, Pix 506 5.2(6):To this point I will need to manually enter my DENY access-list statements on my 506 as we do not currently utilize any type of IDS.In my initial config, I had 1 DENY rule, followed by 5 PERMIT rules and then of course bound to ...
So I noticed today all was not well with my 506. In doing some routine maintenance on our network, I was told external connections to both the SMTP and FTP servers were getting 'scrambled'.The outside interface of our 506 is connected to our ISP prov...
My apologies..Here is the Router config:Current configuration : 1602 bytes ! version 12.2 service timestamps debug uptime service timestamps log uptime ...
Not in a position right now where I can copy and paste the running config..Also, the failed command was 'enc'. it just stated unrecognized command..(or similiar)
