Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I need to retrieve SLB MIB variables from a router agent:
The snmpwalk snmpwalk -u v3user -A v3authpass -a SHA -l authPriv -X v3authpass 192.168.5.202 -v3 works
$ snmpwalk -u v3user -A v3authpass -a SHA -l authPriv -X v3authpass 192.168.5.202 -v...
Hi,I am thinking about purshasing a refurbished physical server for VIRL, but I have a couple of questions.Here are the requirements provided on http://virl-dev-innovate.cisco.com/ :Four CPU cores and 8GB of DRAM, more resources allows for larger sim...
Hello everyone,To practice QoS I build a trivial topology (attached image) to simulate a link bottleneck: - A WAN connection 1.544 mbps between two LAN, both r1 and r2 are performing static NAT for the internal PC1 ,r1(inside local=172.16.1.1, inside...
Hi,In a lab environment I have configured multicasting of one video source (using rtp) to a receiver host.All routers are configured for sparse mode with one static rendezvous point.The command mstat at the receiving router shows 95 to 99 percent of ...
Hi,I have a problem with DHCP relay agent on pix configured for simple PAT (Lab envirement)All works fine with client ip statically configured:***DHCPRelay(config)# sh conn1 in use, 4 most usedTCP out 193.168.10.201:23 in 172.17.10.2:2022 idle 0:00:0...
Thanks Vinod for your reply. I switched to snmpv2, looks like help the GUI browser to get some scalab objects, but still cannot retrieve any table through snmptables (0 row) From CLI snmp: Can get any scalar variablestables and their tabular object...
Thanks Geevarghese for the information,Though I have been answered, I must say I am very disappointed by Cisco response.The corporate CML looks very interesting, but not VIRL at least the way it is presented to the community. I was expecting somethin...
Hi Chris,According to Cisco Doc the command defines a pool of IPv6 prefixes (network portion /48) to be assigned to users (/64)So users will get 64-bit network portion addresses in the following form:2001:db8:0055:XXXX/64Important note:IOS version pr...
