Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
All the actives call are disconnected and all the incoming calls bypasses the front desk routes to one 7941 phone and within a minute everything is back to normal. We have a CCM 6.1 with 2 PRIs and our remote office has a SIP CM Exp. I could not find...
Thanks for the response! I am reading on maintaining Call Manager 6.1. I was able to generate RTMT reports but they are too big for attachments. If its okay I can email it to you. Please let me know. Thanks!
Thanks for the reply. Option #2 didn't work thats what the Cisco TAC suggested b4 they send us another card. Should it be just internal clocks for 2 data ports or internal- independent or other options? I am sure lot of companies have 2 data T1 and ...
Joel, any luck resolving this issue? I have the same problem 2 data T1 ans 1 PRI with 2851. If I set PRI as Line Primary and the 2 data as Internal still get slips. Replace the VWIC card NC. Do I set Internal Independent or just Internal. My vendor, ...
Hello Manoj, My ISP has provided me with the IP address for both my T-1s. So, how do I config multilink and what IP add do I use for my multilink?Thanks!
Thanks for your help. Only confussion is both the T1(same vendor) has an ip address provided by the isp. All the PPP multilink load sharing config samples I have seen has serial ports configured for no ip address. Thanks again for you help.
