I have successfully established a site to site VPN tunnel with a Cisco ASA 5505 and a Symantec Gateway 460R. However, the Cisco ASA log is mpushing out tons of this severity 4 log message: "IPSEC: Received an ESP packet (SPI= 0x5E4FE6BC, sequence num...

I am trying to create a dynamic VPN tunnel with a Cisco ASA 5505 and a Symantec Gateway Security 460R device and having major issues. I can successfully establish a PHASE I connection, but when it gets to PHASE 2, I get the following error on the Cis...

I am setting up a new CISCO ASA 5505 to perform NAT, but when I specify the static IP on the outside interface, it only allows me to put in the static IP and the mask. There is no option for putting in the defualt gateway and DNS servers that the ISP...