Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have an assignment where I need to design a network with 4 subnets and 50 hosts each.For each of the subnets, I was going to use a 4500 series LAN switch with 2 WS-X4148-RJ cards. Now, if I use a router for each subnet, what router should I use to ...
I can?t figure out how to do the commands for an ACL list to protect the first subnet from the other three while still allowing the first one to have outbound traffic.Here are the addresses:IP 221.221.221.0 Sub 1 221.221.221.0 Host 221.221.221.1 > 62...
Thankyou. Now I do remember that an ACL has to be specific to the router it resides on.If I have individual WS-X4148-RJ 48 port cards plugged into the switch, then i can configure them separately?And on one of the cards, I can specify an ACL?
I explained my situation too vaguely. I don't actually have any of this equipment. I need to design it on paper for a final term paper assignment for the class I am taking.Here are the requirments that were set forth for this:with 4 subnets and 50 ho...
