Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a 1602 (non-r) that is giving me an error on boot up and I cannot seem to find any reference to the error on cisco.com or anywhere else.The bootup screen looks like:System Bootstrap, Version 11.1(10)AA, EARLY DEPLOYMENT RELEASE SOFTWARE (fc1)C...
Do you have a RP set up as well? One of Cisco's documents on multicast states: "A router is still necessary with IGMP snooping to provide the IGMP querying."I am guessing you just need to configure a router with 'ip multicast-routing' in config and...
dreemweaver,My assumption here is you want the Cisco 1710 to act as, basically, a broadband router. In other words, it will perform NAT and act as a DHCP server for clients in your network. A template for NAT configuration for most Cisco routers ca...
I would try some of the show flash: commands to see what it sees in the ATA card (http://www.cisco.com/en/US/products/sw/iosswrel/ps1835/products_command_reference_chapter09186a00800ca742.html#wp1018357) You should be using a Class C filesystem.I am...
