Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,We have a pair of ASAs, and we use the prompt hostname state command to display the active or standby status in the hostname.Now, we have a pair of FTDs managed via FMC. We sometime need to SSH into the FTDs to check the configuration, we are look...
We have several VLANs on the network, and some devices on the management VLAN are experiencing significant packet loss.I suspect there might be an issue with the firewall pair. When I checked the interface for the management VLAN, I noticed traffic o...
Hi,We upgraded a pair of ASAs from version 9.14.3.18 to version 9.18(4)40. After that, we could not SSH into the ASA. At the moment, we can access the firewall via the console.I turned on debugging on the ASA while I attempted to SSH. The log file in...
Hi,I tried to understand a spanning tree setting on an old switch so that I can move it to a new switch. The configuration on the old switch is as below:spanning-tree mode mstspanning-tree extend system-id!spanning-tree mst configurationname BACKBONE...
Hi,We have a VPN site to site tunnel between USA and Asia.The firewall in Asia can ping the Firewall in USA well, no packet loss.However, a Asia Server 10.89.100.5 ping a USA server (10.0.99.73 has packets loss. Packet capture ASP drops show somet...
Thanks Aref, I tried and it worked like a charm.ctrma-ftd-1/sec/act# show failoverFailover OnFailover unit SecondaryFailover LAN Interface: FO-HA Ethernet1/11 (up)Reconnect timeout 0:00:00Unit Poll frequency 1 seconds, holdtime 15 secondsInterface Po...
packet capture shows firewall reset the connection. I did try create new key and upgrade putty, it did not helpcolo-fw1/pri/act# show cap capin6 packets captured1: 13:37:19.791127 10.0.99.39.49044 > 10.0.99.250.22: S 2888070741:2888070741(0) win 2920...
Thanks.Unfortunately, our contract has expired, and we are in the process of renewing it. It will take some time.I tried all the suggestions, including upgrading my PuTTY to the latest version and changing the SSH settings.At the moment, I believe it...
