Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi.I have a Cisco Catalyst 6509 switch with two supervisor engines VS-S720-10G-3C and I need to know if it's possible to configure in active/active mode?. Or is only possible in active/standby mode?.In the event that can be done in active/active mode...
Hi.My problem is the following.A switch Cisco Catalyst 3560 of one of our customers, model WS-C3560G-24PS-S, have three ports (3, 4 and 6) that don't give PoE. The other ports work fine.I've reviewed power inline parameters, and where I run debug of ...
Hi.I have a Cisco Catalyst 4510 switch running as CORE in an industrial network. The network consists of several switches RUGGEDCOM using GVRP protocol. How can I connect them to the 4510 switch using VTP?. This because the 4510 has IOS and GVRP was ...
Hi.My problem is as follows.During tests for authentication through the wireless network with the iPAQ 610c smartphone, this authentication does not work with the AP 1231 but works with the AP 1300. The AP's are the same, and I did the update of the ...
Thanks Robert for your response.The devices are authenticated against a RADIUS server using IAS. With other devices we have not done the test.Thanks again for your help,Ramiro
Thank you very much Jon.then for my case the setup would be:Switch(config)# ip access-list extended 8010Switch(config-ext-nacl)# permit udp host x.x.x.x host x.x.x.x eq 8010Switch(config-ext-nacl)# exitNext, create a VLAN access map named map2 so tha...
