Catalyst 6500 active/active supervisor engine configuration

[rmarulandazapata]

Hi.

I have a Cisco Catalyst 6509 switch with two supervisor engines VS-S720-10G-3C and I need to know if it's possible to configure in active/active mode?. Or is only possible in active/standby mode?.

In the event that can be done in active/active mode, where can I find information?

Thanks in advance,

Ramiro Marulanda Z.

[Collin Clark · Accepted solution]

Active/Passive only. Active/Active doesn't make much sense since both chassis are active in Active/Standby, just the SUP isn't.

[IAN WHITMORE · Accepted solution]

You can find more info here:

http://www.cisco.com/en/US/docs/switches/lan/catalyst6500/ios/12.2SX/configuration/guide/vss.html#wp1063718

http://www.cisco.com/en/US/docs/switches/lan/catalyst6500/ios/12.2SX/configuration/guide/issu_efsu.html

...but Collin is right.

HTH,

Ian

[rmarulandazapata]

Thanks Ian. Your response perfectly complements the previous reply  of Collin.

Regards,

R@M

[rmarulandazapata]

Thank you very much for your response Collin. Your support has been very valuable!

Regards,

R@M