Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
I've tried a couple of times, i am not receiving email with the VPN details for the DEVNET sandbox(s). I've got one active (e58dc3a8-8bcb-4386-834a-10f95da9580c) at the moment if that helps.
Thank you.
Regards,
Jay
Hi,I have a router with a static route and a floating static route for a destination subnet via two different physical interfaces.The requirement is to backup the primary link using a backup path.But during the testing i found that it takes around 25...
Dear all,There are two branch offices of a customer connected to a PE router. One of this link(CPE1) use EIGRP as PE-CE protocol and the other one(CPE2) use STATIC. I have attached a diagram to get a clear idea. I have redistributed the EIGRP routes...
Hi, I am jayanthan, new to this forum, seeking a solution for a problem on implementing a type B inter AS.Two MPLS Autonomous Systems, AS1 and AS2 connected via ASBR1 and ASBR2. ASBR1 and PE1 belongs to AS1 and ASBR2 and PE2 belongs to AS2. There i...
Hi Bob,
Thank you. Thats my email. I dont see the emails, i will check in the spam. And thanks for the details about the OUTPUT where i can find the details.
Regards,
Jay
Hi,Really appriciate your design, but please see the attached diagram to view the requirement. Sorry for not providing it in the start.The availability required is 99.9999. The only router as shown in the diagram is used to handoff the traffic to cli...
If you are running BGP as PE-CE routing protocol then you need to configure the neighbour statements inside the address family in CE also.You need to configure the neighbour peering for each vrf.or else you can configure in the router bgp AS ...and t...
Yes you can create two vrfs and bind each for two subinterfaces of an Interface.But in the CE you may have a LAN interface and you have to bind that LAN interface to a particular VRF to see it in the VRF routing table.If dont have subinterfaces in th...
