Hi,the same AS number is used in CE1 & CE2 so they will not accept routes coming from the same AS nu...

Hi Edison,we can't filter outbound intra-area routes because we can't filter LSA type 1&2 (topology ...

Hi Michael,the same AS number is used in CE1 & CE2 so they will not accept routes coming from the sa...

If the uplink interface will be used only for internet traffic you can bind this interface to anothe...

Hi,1-Try to configure default route into the vrf for upload traffic with global key word:ip route vr...

Hi,cRTP changes the packet header and, therefore, must be decompressed before routing can take place...

yes the route has to be selected and installed into the global or vrf routing table to be redistribu...

Hi,1-static --> bgp you will get the route in bgp table but will not be selected in the vrf routing ...

Hi Jon,Sure it is very useful memories.Regards,W.Amer

Hi,If next hop for MPBGP routes is the directly connected interface for P router, the P router who w...

Hi Mohamed,what about internal network the two routers will run HSRP or connected to L3 Switch, beca...

Hi,i think you need to configure PIM on physical interface, PIM under VLAN not enough to let the rou...

hi,the BW configured for the interface or for the ima not used for data transmission, the data will ...

Hi Orlando,You need 3 vlans per DSLAM one for each service and change vlans per DSLAM to eliminate b...

Hi friend,Check below link you will see total cost for default route is 65 (1 is the cost advertised...