Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have sup-1a-2ge with msfc2. Can i boot an msfc image from the slot0.I have read that it is not reccommended to boot catOS from slot0 because of a couple of bugs.regardsmark
can i use c6msfc2-boot-mz.121-2.E and c6msfc2-dsv-mz.121-8b.E15.bin on my msfc2 together when using cat6000-sup.6-1-1b.bin on a sup-1a-2ge.I recently purchased an upgrade (c6msfc2-dsv-mz.121-8b.E15.bin) but i did not get a boot image with it, or do i...
I recently upgraded a 6509 from cat6000sup.6-1-1b.bin to cat6000supk8.8-2-1.bin and encountered an unusual issue.This 6509 has redundant supervisor 1A and msfc2's with the msfc2's running c6msfc2-ds-mz.121-2.E.bin.After upgrading the supervisors i fo...
I have a 6509 with two sup 1a with pfc and two msfc2's. From the switch i can ping all vlan interfaces on msfc1 (slot 1 on active supervisor) from the same switch the only interface i can ping consistently is the vlan that the switch has its manageme...
Thanks,do you have a link to where i can find out about the availability of bootloader images.I recently purchased software upgrades but only got main images with them, do i need to buy these seperately - i do not have a cco login so i cannot downloa...
The image on my msfc's did not support config-sync - support for this did not start until 12.1(3a)E1 and i had been using 12.1(2)EAlthough as i said before this setup had been working fine this most mean that 8.2.x has picked up something that 6.1.x ...
When looking at documentation and part numbers for images yesterday, most of the boot images were marked as not orderable. If not how do you get them, i cannot download them as i do not have a cco log in.Should i just ask my supplier.regardsmark
This happend last week when i was busy reloading images and configs after an upgrade problem but has not happened since i got everything sorted out so i will not progress this unless it happens again.We do not have smartnet so i cannot open tac cases...
I will go over this again to make sure but the configs were the same on the msfcs before the upgrade and were working ok.I am running hsrp for redundancy, downgrading to 6.4(7) is not an option as i have new hardware to support which recommends 7.x (...
