Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Is there a document that explains the difference between the feature sets available for IOS software? I would like to know if I'm choosing the right one. Up to this point, I've downloaded new IOS based upon the feature set already on the router. But ...
I have a T1 for Internet access set as the default route in my router (ip route 0.0.0.0 0.0.0.0 interface). I have a new T1 that I want to route our SMTP traffic on. The ISP says to point to DNS name mail.global.frontbridge.com, which resolves to man...
About a month ago, I used a tool on Cisco.com where I could specify a WAN modules and see what IOS trains were compatible with it. For example, I know the VWIC-1MFT-G703 interface is compatible with the 12.1T train but not the 12.1 train. However, I ...
Replacing and old RAS box with a 2620 router and NM-8AM module solution. I have followed the sample configuration at http://www.cisco.com/en/US/products/hw/modules/ps2797/products_configuration_example09186a00800e0dcd.shtml, but when trying to test w...
I was...until I remembered there are other internal SMTP servers at our Corporate headquarters and sister divisions, so I can't route all SMTP traffic out the new T1. I thought I could create multiple access lists and the route-map like this:access-l...
Thanks for your reply Michael. I have already done what you suggested for inbound traffic, all is well there. The part I'm having trouble with (although I now have some good suggestions to try) was the outbound to all those disparate IP addresses.Tha...
That's the direction I was heading. I can't tell from your post, is there a way to create the map based on protocol rather than IP address? That would be preferred, but from what I've seen so far that is not the case.Below is what I've written so far...
I thought that was the tool too, but it doesn't support the 2600 or 1700 series router. I see that the tool is new/updated, maybe the update has been within the past month and they haven't added the functionality for those series into the updated too...
