About gondarmonn

gondarmonn · 08-31-2011

Hello everyone!I thought I was done with configuring that device, but I am hitting another roadblock.I am working on two SGE 2010 stacked and in routing mode. Everything work fine but before finishing the job, I wanted to lockdown all the network dev...

gondarmonn · 09-03-2010

Hi all!We currently have several links (XDSL) to one provider with static routes and several IP blocks provided. We are getting an E10 from a different provider ; we are planning on getting our own address space and running BGP. The first provider wo...

gondarmonn · 10-07-2008

A quick question:- From our gateway, when I run sh ip cef exact-route [customer ip] [some ip], I get a different next hop than the one listed when a traceroute is done from the actual ip ....Does that mean there are inconsistencies in the cef FIB ?Ho...

gondarmonn · 10-01-2008

Could someone kindly advise me on this problem ? I am having lots of errors on all interfaces of a 7204VXR ...Find below the output of sh int command:~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~FastEthernet0/0 is up, line protocol is up Hardware is DEC2...

gondarmonn · 08-26-2008

I have been scratching my head for quite a while on this one ...We are a wisp, getting our internet connection from 6 DSL lines through 2 cisco boxes (3 lines on each). The cisco boxes feed a linux machine with 3 Nics that redistribute the traffic in...

gondarmonn · 09-01-2011

YES! David Carr was right, changing the name did it. It was a fairly long name, 20 caracters .....Thanks again Dave!

gondarmonn · 08-31-2011

Thanks for the pointer Dave!I will check that tomorrow and let you know.Gondar

gondarmonn · 08-31-2011

Hi Paul,Just to let you know, my problem was not with the switch, but the DHCP server which had an application that was hijacking the bootp port ... So the switch was doing the right thing all along, but server was not responding except on VLAN 1.Th...

gondarmonn · 10-07-2008

Finally solved it !!! Everything at our end was working smoothly (per destination load sharing), the problem was with one of the links from our provider .... They still can't figure out what the problem is, but after much testing, we found out that t...

gondarmonn · 10-02-2008

Despite what one of the techs told me (port locks up in FD), I changed the settings on the switch (f0/0) to full duplex, bypassed the switch on f1/0 and f2/0 (cross-over to two other routers), matched duplex and speed settings on the routers .... It ...

Member Since	‎09-09-2006 08:40 PM
Date Last Visited	‎08-18-2017 03:54 AM
Posts	19

User Statistics

User Activity

Cannot bind ACL to interface on SGE2010

BGP multihomed 2 ISPs, One won't run BGP

cef troubleshooting

Multiples output errors and collisons on interface

route-map problem ...

Cannot bind ACL to interface on SGE2010

Cannot bind ACL to interface on SGE2010

DHCP Relay on SGE2010

Re: Redirecting http traffic through the originating interface

Re: Multiples output errors and collisons on interface