Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I presently have a WAP offline and WCS continually alerts that the WAP Radio interfaces are down.I am logged into WCS with Admin priveleges, but if I select the WAP and opt to place the WAP into Maintenance State so as to suppress the alarms, WCS rep...
Looking for assistance running IP SLA on a switch with Embedded Event Manager.Switch is a 3560 running IOS version 12.2(53)SE2 and has the below configuration applied , but I have also tried on a router running multiple IOS v12.4 versions.-----------...
Hi,The problem has been identified and is a bug in the latest version of WCS being 7.0.172.0According the Cisco, the Bug is to be fix in the next version of WCS due for release later this year pending code updates for the controllers making them com...
Version if WCS is 7.0.172.0The account I'm logging in with is granted Admin level. Are you advising that Super User Privilege level is required to place a WAP in maintenance mode ? How does the Super User Priv level get assigned if logging in again...
Hi,You can't send SMTP alerts directly from the controllers.The options you have are to configure a Syslog server under the Management tab of the controller to enable logging of alarms to the Syslog server. When the alarm arrives at the syslog server...
Check on the 802.11a/n settings 11n mode is enabled and that you have the "High Throughput (802.11n) MCS Data Rates enabled 7Mbps thru 144Mbps.You will not see the higher datarates in the 802.11a/n Network , this only shows Data Rates 6Mbps thru 54Mb...
Check on the 802.11a/n settings 11n mode is enabled and that you have the "High Throughput (802.11n) MCS Data Rates enabled 7Mbps thru 144Mbps.You will not see the higher datarates in the 802.11a/n Network , this only shows Data Rates 6Mbps thru 54Mb...
