Hello,
In order to get a failover connection, I put an RV320 router in front of two internet connections from different providers.
The RV320 Wan ports connects to the respective ISP modems Wan1 > Proximus , Wan2 >Telenet (local ISP)
Sadly, when e...
Hi,
The rv320 (v1.3.1.12) is set up with two different ISP providers - dual wan with load balance (auto mode)
Since yesterday Wan1 (isp1) is very slow to unresponsive, due to maintenance.
The rv320 does not seem to detect the problem.
It almost a...
Hi,
I have two offices connected by cisco rv320 , latest firmware V. 1.3.1.12. using a VPN Tunnel.
The internet connections at both offices are Fibernet 200Mbps down/20Mbps up
Logging on the domain from the remote office takes too long, accessing th...
Hello,I am trying to setup a vpn gateway between 2 sites using 2 new cisco RV320 VPN routers.(Firmware v1.1.1.19)
I followed this cisco article:
http://sbkb.cisco.com/CiscoSB/GetArticle.aspx?docid=00645babb1594fa09183f20ad79c2f40_Gateway_to_Gat...
Hi,Thank you for the NSD information. This seems exactly what is needed.I must have overlooked that setting initially. Later on, I mainly searched in setup, not system mgmt.Thank you
Well, I am glad to be proven wrong.
After the successful update of both routers to firmware 1.3.1.12, the test vpn tunnel immediately connected. Pings in both direction work.Further tests will follow tomorrow.Perhaps important, the Cisco support pers...
@benhA very helpful cisco support guy suggested the same - he said the vpn config was correct.One upgrade is already done - as you stated - easy and painlessly.The configuration is retained over the upgrade - the vpn tunnel config will be rewritten a...
