Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I flashed a single Cisco Aironet 2701 (Cisco AIR-CAP2701l-E-K9) with a Standalone/Autonomous image.If I create an open WiFi I can connect to it and I get an IP-address. So far, so good. but if I try to set up a WPA2 network, my Windows Client a...
are you kidding me? XD It works now.The current driver was relatively up to date (updated last month). But with the new drive update it worked, I never thought that this is the fault.... I spent a lot of hours in this.... thank you very much XD
Hello, thank you for your answers, here is the config of the ap (and I attached the Windows error message - sorry it's german): Building configuration...
Current configuration : 2225 bytes
!
! Last configuration change at 17:23:53 UTC Sun Mar 7 1993...
