Hi all,Looking to design/deploy a couple IoT enterprise wireless networks. One of the WLAN networks will have access to the Internet only. The second WLAN will have access to the Internet as well as the internal (trusted) network. Could I leverage...
Hi all, Is it required for an Cisco outdoor 1562i or e model to have a NEMA enclosure installed as well? The data sheet mentions humidity are levels 0 - 95% , non-condensing. So I'm guessing that they're required?Cisco Aironet 1560 Series Outdoor Ac...
Hi all, I'm attempting to build a mobility tunnel between an AireOS virtual wireless controller (8.8.130) and a C9800 virtual wireless controller ( 16.12.1s). Are these models and software images compatible for creating a mobility tunnel? The link...
H all,
Does anyone know why the placement of the Cisco ISE Web Auth portal is located within the internal network for this design guide below? Is that the preferred security design? Figure 21-4.
https://www.cisco.com/c/en/us/td/docs/solutions/En...
Hi all,
I have a basic wireless lab configured (diagram attached), yet the Windows 7 wireless client doesn't not obtain an IP address. If I attach a wired Windows 7 PC to VLAN 95, it obtains an IP without a problem.
I have the LWAP statically co...
The challenge is that I have to put each group of IoT wireless devices into DMZ zones and not on the internal network. But I'll take your appreciated advice and add a second anchor into a second DMZ zone that allows access to the internal network....
Thanks for the response. We're looking at installing some of that model but they may get exposed to rain. I'm looking at the AP data sheet, but I couldn't find any information about being exposed to storms.
Thanks Flavio. I guess I could see reasoning on putting the web auth portal on the DMZ. But it seems secure enough to place within the internal network,.
-Mike
Kurram,
Sorry for the delay.
Did you try connecting to the SSID via Cisco AnyConnect or Windows native wireless? I couldn't get it to connect via native, but I finally tried from Cisco Anyconnect client and it worked! I didn't think about using th...