Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,During BIOS upgrade, one of our b200m2 servers has corrupted.We tried to recover bios, to revert to previous version, to re-flash, but without results (we tried this many times )We also tried cmos reset with cmos_reset jumper, also tried to put ...
Hi,There is a need to reconfigure existing IBM server, and attach it to nexus 5596UP switches with FCoE.For that, we have purchased emulex vfaII adapter with fcoe license, and 2 twinax 5 m cables.I am about to consider configuration details.First, i...
Hi,We have one demo UCS system. It was working pretty smoth, we take it to few presentations etc etc.Few days we cleaned system, and decided to reconfigure and deploy.Overview :Cisco UCS blade chasis, 2 b200m2 servers with VIC adapters, 2x6128 FI.Upl...
Hi everyone,I need some help about VSAN/VLAN configuration in UCS 2.0 (1s).Previosly i used to create VLAN dedicated to FCoE traffic, and then create VSAN and map it to previosly defined VLAN to carry trafic. And that works just like it should.This m...
Hi,I am connecting UCS system to storage with mds9124 in between.So far i have integrated 2 UCS systems, everything went smooth.Now, new UCS system has arrived, it is same as before, only difference is that now we have PALO for first time.Stanard con...
Just to clarify, i think that this port is going to pass ethernet traffic (this is supposed to be trunk port) and that no specific confiuration is required . But i am not sure
Maybe best thing is to power down hosts, reconfigure vlan and vsan mapping and reboot hosts.I mean if hosts are not Boot from san, you will have only short SAN loss, but in order not to loose data or risk for some problems, maybe it is safer to stop ...
well, server ports are up. I know this is uplink ports problem, but really cannot see where the problem is :). Ports on northbound switch that ucs connects to are trunk ports, vlans are defined on that switch.I also suspect sfp's (cisco glc-t) but it...
just few more thingsProces of server reboot (re-associating service profile, i got hint that thos may help)1. Virtual circuit for DCE interface is cretaed, state UP. Eth0 and eth1 VC are created status unknown2. Esx (installed on local disks) begins ...
