hiya,Is is possible to enable client to client communication using an 7140 with the Cisco VPN client ?I'd imagine it would have to be configured something like this:ip local pool ippool 10.10.20.20 10.10.20.60and then use the following acl to classif...
hi,The PIX can log the following sort of messages to a syslog server:<snip>PIX-5-304001: 10.200.25.56 Accessed URL 211.188.40.169:/12-14-2003 20:39:19 213.214.100.4 local4.notice %PIX-5-304001: 10.200.25.56 Accessed URL...
hi,I've been searching for a while for possibilities to remotely check the backplane usage of 2950 and 2924XL switches.The only way I've been able to find is to use the buttons on the front of the switch and look for the UTL stats, which displays the...
Hi,I ran into exactly the same issue whilst installing ESXi 6 .My solution was to boot an ubuntu 15.04 server cd, change console to second screen and use fdisk to manually delete the (only) partition from the flexflash storage. After doing so I was a...
I've seen this happen in situations where one side uses a form of pfs (perfect forwarding security) and the other side isn't... so you should make sure that they match...Frans
Thanks for your response, we tried adding a route(ip route 10.10.20.0 255.255.255.0 f0/0)but to no effect. I noticed that the virtual interface on my workstation gets assigned a netmask of 255.0.0.0 when using the 10.x addresses. Changing the pool to...
