Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,Is there a way to block a specific MAC-address on a ME-3400 switch from entering the mac address-table. Setting up a mac access-list isn't what I'm after. The key here is to prevent the switch from learning the specified mac-address in the first p...
Hi, I was wondering how policing works on a 6500 with PFC3/Sup720. I would like to setup policing to 5Mbit in one direction and 10Mbit in the other direction. Can I setup different policing on input and output vlan interface? What’s input and output ...
Hi, When configuring [auto qos voip trust] on the interfaces connected to the phone, auto qos enable priority-queue out on the specified interface. However auto cos will not enable priority-queue out on the uplink interfaces g0/1-2. Is it necessary t...
Hi,Is it possible to setup add another endpoint in an existing QinQ setup?Today we have a QinQ setup between to ports on different switches in our network. Now we want to add another port/switch to the same QinQ setup.
Disabling WREDI'm running QoS on my 6509 with WS-X6748-GE-TX which I'm only running IPTV (UDP stream) in queue 2 marked as af41, nothing else. I don't see any point in running WRD since I'm not competing with any other traffic in that queue. Should ...
Well there actually 3 things I want when a certain mac address enters a fa-port. First off, the ME switch should not learn the mac address on that port, secondly block all incoming traffic with the source mac address xxxx.xxxx.xxxx, lastly we need to...
This is what one of our switches reports after we just have telented into it. The CPU drops to a normal level just after we telnet to it. 11111555555555555555555555555555555555555555555555555 66666222220000033333222221111122222111114444433...
Thanks for clarifying that Laurent.But what if I want to setup different policing speeds on input and output vlan interface? Is that possible since there are no input/output directions like a physical interface?
