Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I have problem with my Dial-peer. I defined dial-peer 2 with 4 codes to prevent all staff calling International , except those who have the code.I realized that I cannot call Emergency number like 911 or 9102 and some National number 908034567...
Any help please?I have two ASA firewalls connected to same layer 2 Switch and with different subnet on Inside interface . ASA-1 ================>[ layer 2 Switch]<====================ASA-2 ...
Hello All,Could someone point out , what is wrong with this Configuration .When I removed the Voice-hunt and call 4067062162 from outside the Phone did not ring , but when i replace Voice-hunt and called again it rang , but the BACD & AA did not wor...
Hello ,I need your advice on what to do to make this work please.I am having problem in translation-rule on CME, I have 4 VOIP Dial-peers to remote branche office, the other three Brache office are finebut the fourth one has the same extension as Fra...
Hello ,Could anyone locate where is my error please? Below is my configuration application service aa flash:app-b-acd-aa-2.1.2.2.tcl paramspace english index 1 param number-of-hunt-grps 2 param menu-timeout 6 param dial-by-extension-option 5 pa...
Thanks ,It works and I realised that one port connected to switch for ASA-2 was in trunk mode , while the ASA-1 was access mode. I removed this and was able to ping both side.Regards,DaKSent from Cisco Technical Support iPhone App
