Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
In this PMS installation I am successfully posting one-way charges. However when I use the Bi-Directional page set, I do not get any successful logins. I've checked the Athdmn database, specifically the HotelGuestData table, and this is not populated...
The scenario is a WISP. I am using Upgraded 350 APs and 1230s.I am successfully able to reserve and allocate IP addresses to the BVI interface using MAC addresses as a parameter.However does anyone know how I can allocate the Default Gateway, Hostnam...
Q1) Is it possible to use a 350 Bridge in root mode and have clients as well as other 350 Bridge (non-root w/o clients) associate to it?Q2) Will a non-root bridge roam seemlessly between two root bridges that are widely separated?ThanksHenry
I have 2 sites separated by a 5km sea. I want to connect a LAN on a ferry to only 1 site at a time (limited by ETSI-regulated power and hence range). Can I use an all-bridge design and have the 350 bridge on the ferry roam between the two sites? How ...
Something similar has occured to me and it's giving me a big headache. In a nutshell the culprit is the DHCPRELEASE message generated by a client when it disassociates from an accesspoint or the client shuts down. When this happens the DHCP on the BB...
If I'm not mistaken, and here I stand to be corrected, the least congested setting comes into action only at boot-up or when applied. Once a frequency is chosen this will not be changed automatically no matter what frequencies appear after the boot-u...
