Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,i try to setup a mesh network (bridge) to connect two building together. The mesh network goes up successfully but can't pass anything over the other building.Here is my setupWLC5520 version 8.5.160Two AP 1562D, one as RAP and one as MAP, both eth...
Hi,
We have a problem with vlan tag and we want to know if it’s the way we build our network who’s incorrect of if it’s the function isn’t fully supported on our equipment.
We have a core switch Catalyst 3750 with ip service activated, so it’s the co...
Hi, I have a Cisco Catalyst 2960X-48LPS-L iOS version 12.2(55r)SE
I have a port linked to another switch (D-Link DGS-3120)
The config of the port is only
switchport access vlan XXX
I suspected some loop on the link so I try to activate the "down-whe...
Hi, I have a Cisco 6509 Chassis with these module inserted
1 10 WiSM WLAN Service Module WS-SVC-WISM-1-K92 8 8 port 1000mb GBIC Enhanced QoS WS-X6408A-GBIC4 48 CEF720 48 port 10/100/1000mb Ethernet WS-X6748-GE-TX5 2...
Hi, I know that many years ago the questions was asked but I want to know if now Cisco have a Cisco ip phone model who's sealed and are water resistent. We need to install some phone in food laboratories and might be splashed with water when we clean...
I was able to resolve my problemOn the switch where the MAP reside I remove the sw tr nat vl and but switchport access vl 999 (a dummy vlan) and now all seems fine.I can ping and manage the switch on both side of the bridge. Thanks for your help and ...
Hi, I try to separate native vlan but nothing changehere is my current config. I change IP Address of both AP to 172.22.40.251 and 172.22.50.252 (vlan 410)In the Mesh section the vlan support native vlan is 410The gigabitEthernert/0 on RAP is set to ...
Hi, it's working for voici vlan and data vlan but I can't access the switch itself.Vlan transparent is uncheckEthernet bridge is check on both APRoot AP the vlan support is enabled and native is 1The ethernet port is set in trunk with vlan 903 and no...
