Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,I have a ASR1001 pppoe server with 2 wan interfaces. Routes manage by ibgp.I would like to use loopback ip for in/out traffic and use it like pref source. Need this because Radius in this way will see only one IPTry to use RMAP but I cant find...
Hi I add in my cisco ASR 1001 PPPoE Server Open Fiber POPs vlans.Every Open Fiber POP must have a VLAN assign to my KIT. Every customers living in the city behind the POP, will have a customer vlan for reach connection.How can I add multiple customer...
Hi I have a Cisco ASR1001 pppoe server with 2 BGP peering to others two routers.
In Cisco I setup bgp+adress family but when my client start pppoe sessions and router assign to them public ips, 1001 dont propagate these ips /32.
If, in
address family...
Hi, I have a Nexus 3064 version 6.0(2)U6(7) where I connected a L2 protected.When I have a fiber cut, provider switch automatically to backup line withouth problem. When master is going up, they cant switch to the master because flap of Nexus port i...
Hi, I have a Nexus 3064 where is connect a L2 protected.When I have a fiber cut, provider switch automatically to backup line withouth problem. When master is going up, they cant switch to the master because flap of Nexus port is <50ms.They tell me t...
hi thanks for replyi solved the problem with these commandsinterface TenGigabitEthernet0/0/1.1800description ** OpenFiber / POP AN_05 **encapsulation dot1Q 1800 second-dot1q 800-999pppoe enable group global POP VLAN is 1800customer vlans are from 80...
hi,try this command but doesnt work. Radius still see connection using /30 ip and not via loopback.try to disconnect users via Radius but dont do automatically because in Radius I only add loopback ip.
hi I have similar problem.I have a 1001 that have 2 wan interfaces to an asr 1006 that manager eBGP and public ips.Routers is generated by iBGP 1006 vs 1001.I would like to use loopback ip of my 1001 to pref source but I try to manage it with RMAP an...
Hi Harold
I use command
redistribute connected
and now I have scenario I want.
If /32 is announce to 1001 meaning that client is connect to him and can go to internet via 1006 router.
If not, /24 prefix continue to routing to other network
thank you ...
hi,thank you I dont know why I dont use this command first. Always enable in mikrotik routers..now I add this command and I see all prefixes when pppoe client is active!thank you and good work!
