Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, I have an issue that I am not sure how to solve. So I established a VPN site-to-site Ikev1 connection. The tunnel is up. However, I cannot access any resources in the second end of this tunnel, behind the network IP. I started troubleshooting t...
Hi, I have Cisco ASA-5506-X. I am pretty new to this I switched from a dynamic IP address to the static IP address. My static IP subnet is: xxx.xxx.xxx.184/29, hence my subnet mask is 255.255.255.248 and static IP address range xxx.xxx.xxx.186-190 M...
I think I was wrong when it comes to the ip (I checked my computer's IP in th network and it is different) in packet-tracer. I did some tries when it comes to nat and routes. I think that I should not remove the filter because it is set on the peer s...
Oh sorry! actually it is my mistake when copying the current config (I copied the wrong one). The correct one includes the network-objects with .128 at the end of the IP instead of .0. So the current config on the peer side is correct in these field...
Rob. Below there is an output from the commands from your post. I assume that original IP is 192.168.100.0 (looking at show nat detail). However, at the bottom I also provided the output of packet tracer for 192.168.1.0 (since the output is differen...
