Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
WLC 9800-40 How we can enable 2.4ghz and 5ghz after shutdown.WLC(config)#no ap dot11 5ghz shutdown% switch-1:dbm:wireless:802.11a network not supported for this Country Code
I there I have Cisco 9800-40 WLC and enabled http and https. It was working fine before but after few days unable to access through http and https. Troubleshooting step taken:1. check https and http2. Installed new web browser like FirefoxBut no luck...
No, it's not in HA topology. The switchport is configured as an accessport. I am attaching the topology.WLC-MCC uptime is 1 week, 5 days, 15 hours, 49 minutesC9800 Software (C9800_IOSXE-K9), Version 16.12.4a,
I did shutdown and no shutdown. It didn't resolve .I can ssh to WLC. When I run the show logging command. I don't see any logrelated to http and https.
