Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Why does a company like Cisco / Meraki not have an affordiable Cisco SFP-10G-T-X that they support?For the life of me I don't know why Meraki has overlooked this SPF option. On the MS250's & MS125's with SPF ports a customer need to know that the por...
Do I have to install the duo software on EVERY server that is a member in the domain?
I was hoping I could install Duo on only the Domain Controller & have Duo enforced via Admin OU group policy for domain admin group members for local server login &...
I have a simple two site WAN network with AT&T AVPN (MPLS Site to Site) w/NBFW off the default route, Internet setup WAN using Site A MX68 & Site B MX84 ... Single up-links per site to AT&T AVPN w/ network based Firewall... With a Cisco RV160 Edge ...
1a. Test network A configuration - Pass A. test 1 config - MX68 - Wan2 10.3.x.x port to RV160 Router vlan3 port ~~~>>> Cisco RV160 Router (10.xx.xx.1)~~~>>> ISP AT&T Router (10.xx.xx.2) ~~~>>> NBFW ~~~>>> MerakiDB1b. I Tested the MX68 WAN2 port o...
Test AVPN S2S network ... This should NOT be this hard... straight-up simple VPN setup. NO_PROPOSAL_CHOSEN error is like a BS general error bucket non-informative log error... WTH !!!! The trail and Error troubleshooting is insane - little diagnost...
I use TwinAx Cables between the two Meraki near-edge lan switches, MS125-24 & MS250-24 lan uplink between the switches. Then I use the other SFP+ 10G ports directly to the HPE servers with 10G NIC's. I also have a TrendNet 8 port 10Gb dumb switch wh...
Interesting... I think this makes me require to research more about the SFP & SFP+ standards in detail and implementation achievements in the marketplace. What a minefield of Gotcha's. I most likely mistakenly assume'd Small Form-factor Pluggable wou...
Interesting ... this helped with learning about Cisco's supported Meraki dashboard conversion of some of the Catalyst 9200L-M switches. Even though we run a full Meraki network at our 2 sites, I still don't see the cost benefits of the 9200L-M plus l...
We are seeing this on two network subnets, started all of the sudden this week. I checked the two dhcp servers on each site’s subnet AD controllers. I don’t think I have multi site DHCP issues, I think its the Meraki’s latest switch FW update… we had...
