Hi,
Is there any command that will show all access ports that belong to a specific VLAN?
I need to know if I can delete a VLAN and I need to know if it has any ports belonging to it.
Thank you,
Traian
Perhaps it can be usefull - I did not find any usefull command so far; I am quite sure it can be done much more elegantly :) - this takes a while to finish
Python script to find access ports in a particular VLAN - tried it on n5k...
import re; # ...
I just need to know the access ports, not the trunking ones; I have aproximately 400 interfaces and I need just the access ports so that I can find out whether that VLAN is still in use. - I know I could use VTP prunning, but it's not an option for t...
Hi, It can be done in failover group:preemptTo cause the unit to become active on boot if it has the higher priority, use the preempt command in failover group configuration mode. To remove the preemption, use the no form of this command. http://ww...
Hi,Try this command to see what's blocking the traffic,packet-tracer input DMZ icmp 10.0.0.1 8 0 8.8.8.8 To see the actual packets you could try a packet capture: access-list allowICMP extended permit icmp any anycapture temp interface outside access...
Hi,There is a built-in monitor... " Hardware Health Sensors"You can choose which ones you one to be monitored:FanFan 1Normal Fan 2Normal Fan 3Normal Fan 4Normal Fan TrayNormal Power Supply1.2V voltage in mVNormal1.207 V 1.8V voltage in mVNormal1.83 V...