Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all, I am not sure if my problem is related to here but did not find a better section.I have a problem with Cisco RSP8 when I switch onthe RSP lights both master and slave and did not initialize, I tested with 2 7507 chasises with no success, ther...
Hi All, I have the following configuration for DMZaccess-list permit-outside permit ip any anystatic (DMZ,external) 1.1.1.0 1.1.1.0 netmask 255.255.255.224 0 0access-group permit-outside in interface external1.1.1.0/27 are real ip addresses,the probl...
Hi, I have the following situation 7960 --> CM1 --> GK1 <--> GK2 <-- CM2 <-- ATA186 I want to set proxy h323 on both gatekeepers. I do not want the 7960 to speak directly with the ATA186 after the call admission. But the problem is that after registe...
Hello All I have the following situation on a PIX 520 running 6.2.2I have three interfaces inside, outside, dmzon the outside interface have an access-list which permits icmp from any to the IPs behind the DMZ interface, I have the following:access-l...
Hi,I have the following situation7960 --> CM1 --> GK1 <--> GK2 <-- CM2 <-- ATA186I want to set proxy h323 on both gatekeepers. I do not want the 7960 to speak directly with the ATA186 after the call admission. But the problem is that after registerin...
I ment that the both leds on the RSP - master led and slave led are on, not that I have master and slave rsp. Sorry for not explaining right. Normally when the RSP boots it lights in the beginning the both and then the one led goes off. But in my cas...
I did not find anything useful in the above links that answer my question!Any other ideas ? Does anybody have an idea if proxy h323 is supported in the new 3.3 Callmanager ?
