Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'm configuring a new CBW145AC Access Point and I noticed slow throughput, about 90 to 110Mbps, while ISP is much faster than that. Also if 2 clients are connected then throughput drops to about half on each client making me believe that AP is defini...
I'm trying to setup a C1111-4P with my 2 ISPs. I was able to configure both WAN and I can ping 8.8.8.8 from each WAN as well as Vlan, but when I add the route everything stops working. In addition, one of my ISP allows for IPv6 connectivity but the r...
I confirmed that enabling Mesh fixes the issue.I factory-reset the Access Point, did same day-zero settings only creating administrative user and configuring SSID, but this time enabling Mesh, and done! It now shows "Configured Rate" to be "867Mbps"
Thanks Scott! I tried changing channel width in "RF Optimization" to 80Mhz (and even 40MHz) but it throws a weird error saying "Error in setting IpAddress".Then I was just comparing my settings with the emulator available at https://www.cisco.com/web...
I appreciate the response Rick. When I was looking for a router to buy, I was initially looking at something like Cisco RV340, the emulator for this model shows that you can setup multi-wan and configure a "weight" to each WAN https://www.cisco.com/a...
I ranISR1000(config)#ip route 0.0.0.0 0.0.0.0 GigabitEthernet0/0/0 track 1
%Default route without gateway, if not a point-to-point interface, may impact performance
ISR1000(config)#ip route 0.0.0.0 0.0.0.0 GigabitEthernet0/0/1 253
%Default route with...
I should have disclosed this in first message and I apologize, I work in IT but I am not a network engineer, my network knowledge is very limited to fixing and improving my home network, although it is something I have interest in learning better. Th...
