Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello Folks, I am following this guide:https://www.cisco.com/c/en/us/support/docs/lan-switching/inter-vlan-routing/41860-howto-L3-intervlanrouting.html I have successfully configured a C3750X switch into a few Vlans, one of which is hosting an Airone...
Hi Folks, I am trying to configure an AIR-LAP1142N-S-K9. From what I can see it has a Autonomous boot image. Secondary bootloader Ethernet not enabled, skip ether_initUnable to locate IOS image with name **xx**.Boot CMD: 'boot flash:/c1140-k9w7-mx.15...
Thank you Georg. This and the switch changes have worked. I can see now that the problem, was going back from 101 to 110. The router was not able to send the packet pack. Is there any way to monitor traffic to better troubleshoot the problem? Your pe...
Hi Georg, Attached is the current config. It is still not working. I did include some more DHCP ignore addresses however the two configs are as per your guidance. I have tried a wired interface to remove the wireless, just in case. Wired Client [192....
Thank you Georg, I will try this. I still don't know how you can cut and paste the config and I cannot :-/. I will also compare your configuration to what I had so I can begin to understand this. Cheers.
Still the samecan ping 192.168.101.250 from 192.168.110.10cannot ping 192.168.101.1 from 192.168.110.10Switch can still ping routerSwitch#ping 192.168.101.1 Type escape sequence to abort.Sending 5, 100-byte ICMP Echos to 192.168.101.1, timeout is 2 s...
I am trying to move back to my first L3 config but still cannot remove the line ip route 192.168.101.0 255.255.255.0 192.168.101.1 =============================================Now partial sh run. interface GigabitEthernet1/0/48no switchportip address...
