Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HiWe have a 2811 with CME on with 12.4.15 code on and two ISDN BRI lines. The problem we are experiencing is that outgoing calls are intermitantly working. This is not due to load as I'm the only one on these lines. I can use all four lines if I'm...
We have a 2811 router that runs callmanager express and unity express, with the correct NTP settings, time zone settings and local clock setting. However, the phones that register on it are two hours behind the router time. If I do a show clock I g...
HiI recently installed LMS 3.1 but I'm having some issues with the user tracking in it. We are running Layer 3 6509 for access switches and on these switches, I do not see any end points, be it phones or hosts. We 3560 switches in some locations th...
I couldn't get the link going, but the search delivered the goods. One thing though, I couldn't use the upgrade tool with the image - it chirped something about it not being a valid recovery image. I then did it from the command line of the AP and ...
Thanks for the response. The problem ended up being a voice port that was actually a FXS port that was being used as a dial peer. The dial pattern was hunting between all the dial peers and thus it tried to phone out using a FXS every other time.
Thanks for the reply. It's being managed - dfm has alerted me about duplex mismatches, I've viewed it in Cisco View, it shows up in topology manager everything. The problem turned out to be the @ sign in the community strings - which is weird becaus...
