Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am new to MPLS. I have 2 6500's connected to each other running OSPF & BGP. I really do not know how to describe the exact problem I'm having in details.. so I will be brief. When I do a show ip route vrf aois on the 1st 6500, the default route sta...
Anyone have any tips/tools/suggestions on manually converting a configuration written in CatOS over to one compatible with IOS/Native mode? We will soon be updating/converting our supervisor modules to run Native IOS & will need to update the configu...
Need to know what version is most stable for the 3745, w/ IP PLUS. Specifically on BVIs, WAN, NAT, & ACLs. Current code is 12.3.6c.. and ran into bug CSCin69117. Any suggestions/recommendations would be appreciated. Thanks.- Matt
I recently replaced 2 routers that were connected to each other via a T1 line, running IPSec. The setup is the same now & the link is running just fine, connectivity back & forth, etc. However, I can't figure out how to verify if IPSec is actually ru...
You are correct for the most part. Except.. the default route is being learned through BGP. But here is basically the problem I'm having. I am redistributing that static route from the 1st 6500 to the 2nd 6500 through iBGP. What I need to happen is f...
Redistributing into what? How are you passing/redistributing static routes to the remote router if you're not running a dynamic routing protocol between them? Perhaps I'm confused.. please elaborate. Thanks.- Matt
Rick,Our VPN/wireless setup currently consists of multiple AP's that span across the base. These AP's connect back to the local closet switches, which then connect back to the ITN's (6500 L3.) A VPN concentrator is connected to one of the ITN's on bo...
