Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi allWe have a new client with an existing wireless network (all Cisco). They had a few areas where the signal was poor and running cables was not an option. We have supplied three 2600's and set them up as repeaters but there is still one area that...
Hi all.We have a UC520 with the optional T1\E1 card installed and an ISDN30 line attached. I have tried setting up the caller ID via CCA and CLI but I cannot get it to work. We have 20 DDI's available with 11 in use at the moment. The only number tha...
I havent tried moving it closer. I spent my time on site trying to possition the AP so it connects to one of the wired APs but i cant quite find a spot that connects and gives the coverage i need. I am going on site shortly to see what else i can do....
Hi BrandonThanks for your reply. I had a look at the dial peers (see below for a few examples). Do I have to add translation-profile outgoing CALLER_ID_TRANSLATION-PROFILE to each of the dial peers in the ALL_T1E1 trunk group?dial-peer voice 80 pots ...
