Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello together,
we facing the Issue that our FMC doesn't show all SGTs in the Connection Logging.
Sometimes it shows the SGTs as Source or Destination, sometimes the field is empty and mostly the source SGT is filled as unknown.
We running Version ...
Hello together,
we have a monitoring running in our headquarter and we have several remote sites connected via a S2S-Tunnel connection.
Now we also want to monitor our remote sites via SNMP through the VPN-Tunnel. On the ASA I needed to configure...
Hello all,We would like to set up a MS425 between 2 DataCenters (approx. 100m distance) as a flexible stack.Does the MS425 stack work similar to a C9500 VSS ? For example, is it possible to configure a multichassis etherchannel so that traffic is rou...
Hello together,
we running a Firepower 3130 Active/Active Cluster in our environment - actually we facing the issue that we cant backup that active/active cluster as also described in the Cisco guide.
Is there a way to perform the Backup through FMC,...
Hello together,
we are getting the following error messages in our FMC -> Monitoring -> Syslog.
Do anyone have a solution for that? - We running FMC Version 7.2.2
Thank you!
Kind regards
Nils
@craineri yeah i have a solution for this first you need the ikev2 authorization policy. after that you must check your Tunnel Interface configuration on hub and spoke. If you use like me the command "ip unnumbered loopbackXY" for the virtual-templat...
