Hi,
I am new with DNA Center and ISE.
We have a NON-SDA Network which is to be changed over to 802.1x.
Some Switches are already configured with RADIUS and TACACS and some don't have any AAA Configuration jet so I tried the following Steps to get the...
Hi,
our Costumer has the following Config:
2x FTD 1140 with 6.4.0.11 (HA) on FMCv 6.7.X
I am unable to Deploy. It always ends in an Deployment Error like this.
ChecksumFaild: "the checksum that was received from lina does not match the one received ...
Hi,I recently had to migrate a FTD HA (tow FTD2130) from one FMC to a new one.I installed the FMC in the exact Version and restored a five day old backup from the OLD FMC to the NEW FMC.Everything was the same from the MGMT IP of the FTDs (10.0.0.x/2...
Hi,
We have the following Network design
The FirePower is the Gateway for all Networks.
If Traffic is send from a Client to the Internal Server it has to go through the FTD because of Routing between the Client Network (10.0.5.x/24) and the Interna...
Hello,I witnessed a strange behaviour in two of our eight Firepower Clusters.Affected are one FTD 2110 HA Cluster and one FTD 4110 HA Cluster all on 6.6.5.After a mayor power outage in our DC all Systems went down.(VXRAIL, Switches, Router, Firewalls...
I checked the Design / Network Settings for the Site and put all changes back to the former settings.
(in my case uncheck "Client/Endpoint" and changed back the second IP Address of AAA Network ISE TACACS)
Now the deployment works without any errors....
@Flavio Miranda
I did a "Credentials Validate" and got an Error. So I updated the CLI credentials with the "Select global credential".
Now the "Credentials Validate" is green for CLI and SNMP but deployment without any Templates failed with the erro...
Hi,
I don´t see any input field to paste the image. @RedNectar @Tyler Langston
I tried different Browsers and klick every table in the "my settings" space.
Am I blind?
hi, what about the Device Name and Domain Name?
some Switches have no "ip domain-name" which results in a DNAC Device Name like "[SWITCH_NAME]" and some like "[SWITCH_NAME].[DONAIN_NAME]"
I would do a Template "Change_Naming" and resync this but will...
I did some debug tacacs on the switch and get this.
So, the DNA_USER Cred are wrong.
======================NOT Working TACACS Debug======================
xy:50:46.456: T+: Version 192 (0xC0), type 1, seq 1, encryption 1, SC 0xy:50:46.456: T+: sessi...
.jpg "VIP Mentor"){kind=icon}
