Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I would like to increase the numbers of port for my ASR-1001x router. And seeing this SPA module, wonder if the throughput will be limited to 1Gbps (5 ports sharing 1Gbps)? As the name is shared port adapter…quite a confusing… Cisco 5-Port Gigabit Et...
Currently i have a HP 2920al switch connected as below diagram:
The problem is i keep receiving this error from Cisco switch:
Cicso_backup_root_bridge#sh spanning-tree inconsistentportsName Interface Inconsistency...
Hi,I tried to ping the SVI ip address by direct connected to the 3750G switch access port vlan 10,Switch:interface vlan 10192.168.10.2standby 0 ip 192.168.10.1standby 0 priority 115standby 0 preemptMy laptop:192.168.10.100 So i ping to 192.168.10.1, ...
Hi,Currently our setup as below:Currently is running pvst + on Cisco switch, but the HP switch is running on mst. So how should i make the HP switch redundancy and at the same running proper STP with Cisco (if possible without configuration all Cisco...
i found the issue, since it is using peer-group, so the route-map must be part of the peer-group as well. For example: address-family ipv4neighbor 192.168.1.61 activateneighbor 192.168.1.65 activateneighbor EBGP route-map REDIST-OSPF-TO-BGP
create a static route in your 819 router to tell how to reply your pc ip address range 10.10.10.0/24 via C-3560 interface 20.20.20.2 ip route 10.10.10.0 255.255.255.0 20.20.20.2
is not high as below: hostname#sh processes cpu sortedCPU utilization for five seconds: 15%/1%; one minute: 17%; five minutes: 16% PID Runtime(ms) Invoked uSecs 5Sec 1Min 5Min TTY Process 226 989199448 486960646 2031 4.95% 5.03...
