Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I am getting the following error on my routers:%IP_VFR-4-FRAG_TABLE_OVERFLOW: GigabitEthernet0/1: the fragment table has reached its maximum threshold 16I guess this may be affecting OSPF as I constantly see the following error:Dec 24 09:38:50.685...
HI GuysI hope if someone can help me with my issue:Cisco IOS in use: advipservicesk9-mz.124-20.TRouter: Cisco 2851I have a few site-to-site VPN running in addition to VPN client. All site-to-site VPN have their own individual pre-shared keys whereas ...
HiI have defined a PKI trustpoint on 871 but whilst authentication CA i get the following error:Nov 6 10:57:05.370: CRYPTO_PKI: Sending CA Certificate Request:GET /certsrv/mscep/mscep.dll/pkiclient.exe?operation=GetCACert&message=Synergy-CA HTTP/1.0...
If you are creating site-to-site tunnel between the two devices, you can apply the crypto map to your WAN interfaces and use public IPs to define the cryptomaps and shared key.
Adding NAT will just allow outbound internet connection but will kill the idea of having public IP range. Ask the ISP to add static route on their router for 50.YYY.YY.0 255.255.255.0 pointing to your router (50.XXX.XX.XXX 255.255.255.252).On another...
Thanks for responding SOcchiogrossoI do have MTU and MSS setup on interfaces and as for this scenario, I have "ip ospf mtu-ignore" statement on the interface.
