Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
i believe that this is an easy question. i have a pix with multiple ipsec tunnels. whenever i attempt to work on one of the tunnels the pix hangs and i have to reboot. i believe there is a command but i can't remember it or find it, that turns off al...
i currently have eap-fast running on 1200 access points, acs and i am using the wlsm as the wds. i am experiencing disconnect issues.is it possible to run both eap-fast and leap on the same ssid, vlan and mobility group? i would like to run these si...
does anyone know why the following happens?i am sitting at my desk with a wireless laptop running a constant ping to the gateway. if i watch the client utility, it will periodically reassociate to a different access point. i am confused in that i am ...
does anyone know why the following happens?i am sitting at my desk with a wireless laptop running a constant ping to the gateway. if i watch the client utility, it will periodically reassociate to a different access point. i am confused in that i am ...
i am wondering if there is an ap setting that i am missing. i have configured mobility groups with the wlsm, i have all of the aps authenticating and for my initial tests i have hard coded ip addreses. i have done the walkabout surveys with the wlse ...
I also work at a hospital where we did a major rollout with wireless bedside carts. we were using the new gateway laptops with the 2200 bg cards. i tried all of the latest drivers and they continued to drop connectivity. these hospital applications ...
I was wondering if you have had any luck stabilizing these cards. i have a similar installation running gateway laptops and motion computing tablets in a 5 story hospital. both of these machines use the integrated 2200 bg card. we are running eap-fas...
what we did here is we set up a mobility group for the guest users on the wlsm. we then gave them their own segment with their dhcp addresses and then we set up policy routing and a route map on our 6500 to force all of the users from this segment di...
i think that you are in luck bucause i just had exactly the same issue. what you need to do is enable icmp to pass between the segment with the websites in question and the wlsm. in my case i had to clear the "no icmp unreachables" on certain interfa...
it so happens i am doing the same type of implementation at a hospital/health system also. we are in the process of doing soemthing similar in that if the data pcs and roaming work correctly, we will be rolling out vocera throughout our new facility....
