The post above was for the language error for the bundle error the TUP file is missing the bundle type for example ENH or PRE and this has nothing to do with the language error i posted the answer for above this one requires a case with TAC or a rubuld of the server as you cannot re-install licenses nor add the missing feild with a workaround as mentioned above unless you have not installed the license files yet. ... View more

The language parameter is missing from TUP.ini file that is used by CAD installer. You need to configure the language parameter again and there are two options to do this: 1) Change the language on the server and reboot; ex (change from english to spanish then reboot then change back to english and reboot). 2) open a case with TAC and they can do this via "remote access". ... View more

Hello Frank, Can you kindly shed some light on the scenario as it's not that clear; PRI----CM---SIP_TRUNK-----IVR - the PRI's are located on a GW what is the connection between GW and CM ? - you say calls from IVR fail; does the IVR initiate the call "the application" or is this an IVR part of a customer responce solution with agents that are initiating the calls via the trunk ? - what is the codec used accross the complete scenario ? - when the call fails what do u get ? ex; fast busy ? By the way traces can be enabled and collected according to the following: http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_tech_note09186a0080094e89.shtml Best Regards, Mahmoud ... View more

Hello, Can you kindly provide additional information as things are not that clear to us. Can you provide: - SYSLog - ApplicationLog - Check if any core-dumps are generated via cli "utils core active list". - What do you mean by "hang"; was the phone services down/slow was the server unresponsive to ping or not accesible ? - Exact CUCM version ? Best Regards, Mahmoud ... View more

Hello Yousef, Kindly check the below link: https://supportforums.cisco.com/docs/DOC-12545 Best Regards, Mahmoud ... View more

Well i guess i will stick to what i said earlier  As from what is provided so far: - Call-Manager is reporting a problem with "feature license" - From service list we can see: Cisco CallManager[STARTING]  not started... But also we cannot neglect the fact that this should not render the services OOS; as i can see a number of services OOS. I would suggest you to do the following: 1)       Remove all license files via CLI “file delete license *”. 2)       Reboot the box. After that can you kindly update us if the you can access GUI or not. If not I would recommend to do a repair via repair DVD and then proceed from there to solve any SW corruption that might have occured during upgrade. ... View more

Hello Mohit, Well the problem can be as the message says "NoFeatureLicense"... If a "SW FeatureLicense" is not there services would have problems starting; they would start and stop after a couple of minutes. Can you try the following: - Remove all license files. - Upload the licenses again (Node+Feature+DLU). - Restart license manager and CM service or if feasable the server and test again. Best Regards, Mahmoud ... View more