Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello i have a problem i dont know whats going on , i have 5555-x ips ssp , the initial configuration has been done and i can see that the ip address is the same subnet as the inside interface of the firewall , still i can not ping the ips from the n...
Dear Friends i have a call forward issue , we have a 17 analog PSTN lines, recently we out-source our toll free no and everything in fine . the only problem is that some subscripers are still calling our office .i need to configure an extension "77...
Hi I have 2 ASA5510 and one AIP SSM-10 installed in one of the ASA`s . i want to have a failover Active/Standby but am getting an error ,"Detected anActive mateMate ASA-SSM-10 card in slot 1 is different from mine NOT PRESENT"i there any way t...
Hii have CME7 with CUE7, but i can not transfer calls to external even the allexternaltransfers it set to true ,i don`t know what is wrong if some one can helpthanks
Hi EXP. 1st time for me to work with AIP SSM-10, i have ASA5510 and AIP SSM-10 ,firewall (5510):inside 192.168.55.252outside 87.191.101.1DMZ 172.16.0.1when plug the AIP SSM-10 what ip address i should give it and how can i be abile to make sure it...
I think you need to look again to your video , the Access point still reboot every 30 sec , (please look again) this is the issue it keeps rebooting . any way thank
Hello ,so far i can use the direct connection to the MNG interface and this was success , but when i connect the MNG interface to a switch Layer2 and connect my PC to the other port in the switch , i can not ping the MNG interface .i think there is s...
Hi , still i am unable to reach the IPS SSP (ping,http or https), here are the configration interface Management0/0 no nameif security-level 100 no ip address management-onlyCard Type: ASA 5555-X IPS Security Services ProcessorModel: ...
