Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
When I try and ping a remote address on my vpn 3000 concentrator I get ttl exceded. When I try and tracert from my workstation to the remote address on my vpn 3000 I see a loop. Tracing route to x.3.17.145over a maximum of 30 hops:1 29 ms 31 ms...
The way I understand it all I need for this to work is to purchase a sip trunk from a sip trunk provider for a new office install. I never did anything VoIP related.
Yes, the last line is a typo. I am pinging from my router which connects to the vpn concentrator. It seems like I am pinging through the tunnel to the remote ip address.The vpn 3k has no static routes it uses ospf. The router also uses ospf. The co...
I cannot post the standby and interface stats for some reason.sw1Vlan20 - Group 0 State is Active 7 state changes, last state change 4y43w Virtual IP address is x.x.1.65 Preemption enabled Active router is local Standby router is x.x.1.67, p...
Egress is the problem. We use static routing and I tried to add a static route for the subnet pointing to the virtual ip address. It was not included in the routing table this is because there is a route for a directly connected subnet. The vendor is...
