Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, can anyone help me with how i can find the total down time (or time spent in a status) for an AP over a time period? dashboard.organizations.getOrganizationDevicesStatuses(org_id, productTypes=['wireless'], total_pages='all')Will give the current...
I have the following code that I am trying to test, when some error happen it continues as expected I know some of the net works it will loop through are not wireless but rather than check each i just want to try and if it fails continue. But when i ...
Can any one explain this. In my template (very simple PoC) i have set up 2 vlans each set to use a unique Subnet in the from a /24 from the supernet 10.0.0.0/8 And this works fine. But also have a site to site VPN to the corperate network that has a...
No, we have 70,000+ clients so not possible to ensure every things i upgrades or that manufactures have drivers to support it. So we disabled 802.11v on the networks. If you have a good AP placement design it should take into account client density a...
This is typical symptoms, they are roaming but not due to signal, with 29.4 clients are actively "pushed" by the AP. The event log does not show it correctly as it shows the client both connected to the new and old AP for a time due to the clients no...
That depends what you are doing. For example if you have visitor / guest flow with a captive portal then you need CoA to reset the session after the user has signed on, but this is only normally used with MAB and the long auth inssue down not seem t...
After disabling 802.11r, 802.11W and load balancing we saw a lots less. But I believe this is because prior to 29.5 load balancing only happens during associating, where as post 29.5 it active while clients are connected. So we have left load balanci...
This has the same issue there needs to be something to capture the hooks, store the data and then create a report at the end of the week / month. And this is what i am trying to avoid we have a number of tools that check AP status and so i could for ...
